Towing - knots |
Post Reply ![]() |
Page <12 |
Author | |
Splosh ![]() Far too distracted from work ![]() ![]() Joined: 13 May 07 Location: United Kingdom Online Status: Offline Posts: 497 |
![]() ![]() ![]() ![]() Posted: 08 Apr 08 at 10:27pm |
And always remember... ...If you cant tie knots tie LOTS! |
|
RS300 - 346 :D
|
|
![]() |
|
olly_love ![]() Really should get out more ![]() Joined: 18 Jan 05 Location: United Kingdom Online Status: Offline Posts: 1145 |
![]() ![]() ![]() ![]() |
lorrie drivers hitch
|
|
TWO FRANK-Hunter Impala
|
|
![]() |
|
radixon ![]() Really should get out more ![]() ![]() Joined: 27 Oct 06 Location: United Kingdom Online Status: Offline Posts: 2407 |
![]() ![]() ![]() ![]() |
May sound like a daft question but what boat are you towing?
I tow a Laser and an RS200 (separatly). I tie both down with two straps, one ratchet strap over the middle of the boat, the second towards the front to keep the bow down. The Laser doesnt move cos I tie it down to the trailer and the road base separatly. The RS I tie to the trolley using the normal method, but also the bow down to the trailer. The issue I found with that was the boat does slide back, because of the angle from boat to trolley, but just checked after a while and tighten if necessary. (Hope this makes sense, but basically tie down halfway from the bow to the centre tie down!!) |
|
![]() |
|
DaveL ![]() Posting king ![]() ![]() Joined: 28 Oct 07 Location: United Kingdom Online Status: Offline Posts: 111 |
![]() ![]() ![]() ![]() |
when tying the boat to the trailer i use halfhitches, when the trolley is attached to the trailer i create a purchase system out of rope then pull tight and tie off with about 4 half hitches, nice and simple. i sometimes use ratchet straps but always remember to put pads under the sides otherwise you could cause damage
|
|
Contender GBR443
National 12 - 2859 "Dogmatic" |
|
![]() |
|
Nudge ![]() Newbie ![]() Joined: 08 Aug 06 Online Status: Offline Posts: 10 |
![]() ![]() ![]() ![]() |
Sounds a simple question, but I’m stumped. What’s the best knot to use when tying the bow of a dinghy to the trolley/trailer when towing? I’ve tried a few knots and how ever tight I make them after a bit of wiggling the rope becomes a little slack. This slack I presume will allow my nice dinghy to bounce up and down from the many potholes we have on our roads which I guess will equate to a broken dinghy over time. |
|
![]() |
Post Reply ![]() |
Page <12 |
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |