Crazy Ideas!

thanks i will stock up and start making

so were can i get these things from to make my own things because i have finished school and am currently doing nothing so i would like to do some nice work for our new boat and try something new

Edited by Ginger_69

Originally posted by Peter Rhodes an asymetric gives less speed on very deep courses whereas a symetrical kite isnt so good for reaching therefore a symetrical spinaker is better for the majority of the time you would use it and is more versitille anyway

Which is why you don't sail an asymmetric very deep downwind!
for example if there is a choice between 2 gybes to make the bottom mark, or just sailing very deep for a short distance - the 2 gybes always wins!

However the boat speed in a light dinghy doubles or more once you get planing / apparent wind sailing, and this easily makes up for the extra distance ( x 1.4 for 45 degree angles compared to straight).

But in keelboats (as in the Hyde polars ), the boat speed doesn't change as much reach to run, so they tend to use full asy kites that project to windward to go as deep as possible without losing too much speed.

With the bigger asy kites on more skiffy boats, it's not possible to reach other than 45 degrees (or less if it's blowing ) off dead downwind

Frank Bethwaite tried an asymmetric kite on a Tasar, but he reckons it's slower than without using it! ( the extra speed not enough compensation for the extra distance )

When you look at blocks it should say what size rope it is made for. Because Cherubs are a development class you can use what you like. It's not like the topper where u have to use a certain size rope, or a certain size block or whatever. Just use whatever you want, normally the cheapest.

Incidently, I just turned Strawberry into a twin tiller extension, and i reckon I made them both, bearing in mind they're carbon and 6ft long, for cheaper than a single topper one would cost. And it only took me half an hour!

ok thanks i will look at prices for it