29er GBR 074 Tynemouth |
J24 (Sail No. 4239) Dartmouth |
Laurent Giles 'Jolly Boat' Exeter |
List classes of boat for sale |
Too many paint choices. |
Post Reply |
Author | |
E.J.
Posting king Joined: 19 Feb 06 Online Status: Offline Posts: 184 |
Post Options
Quote Reply
Topic: Too many paint choices. Posted: 02 Sep 18 at 9:27am |
Hi informed boat fetters,
I am going to strip back and refurb all foils. Q1. For the foils I had been pointed at 2 pac such as international perfection but was warned that it may not handle thx flexing so well and that Toplac would be better but softer. Which is preferable (not the brand but the type), if it’s even, my main requirement is that they can be buff to a high gloss with cutting compound and a sander/ polisher, so the winner needs to allow this. Q2. Whichever the winner, what is the best way of application to reduce paint brush marks? In the past when flatting back the paint and subsequent polishing has removed too much paint in patches and required me to start again. Any tips would help. Regards EJ |
|
Daniel Holman
Really should get out more Joined: 17 Nov 08 Online Status: Offline Posts: 997 |
Post Options Quote Reply Posted: 02 Sep 18 at 10:06am |
durepox has a good balance of being bendy but hard (ie doesn’t scratch)
Buy the primer and the clear. Buy the slow thinners (slow reducer) for brushing. Roll And tip 3 layers of half and half primer and clear about 10% thinned, flat back to 400grit. Final glamour coat half and half clearcoat and primer, thinned 40% . Use a good foam roller. And tip off with a high quality brush like red tree or purdy monarch elite. Keep wet edges work fast only working a small area at a time. If you are lucky and good and dust free that will flow out fine. If you have runs dust etc, flat back next day. Leave a couple days somewhere warm to get hardness required for good polish. Clean your expensive brushes and leave them in the slow thinner. |
|
JimC
Really should get out more Joined: 17 May 04 Location: United Kingdom Online Status: Offline Posts: 6649 |
Post Options Quote Reply Posted: 02 Sep 18 at 10:50am |
What are the foils made of? Wood, glass over wood or what?
These days I'm a believer in not stripping foils if the paint is good, but simply sanding right back and refinishing. Saves a lot of work because there is so much less filling to do. |
|
E.J.
Posting king Joined: 19 Feb 06 Online Status: Offline Posts: 184 |
Post Options Quote Reply Posted: 02 Sep 18 at 3:42pm |
They are wood, I would love to simply sand back and recoat but some idiot (me) has used some dodgy spray paint as a stop gap and this has gone very soft in the heat an so needs to be fully removed.
|
|
JimC
Really should get out more Joined: 17 May 04 Location: United Kingdom Online Status: Offline Posts: 6649 |
Post Options Quote Reply Posted: 02 Sep 18 at 4:20pm |
If you decide to use International two pot it will almost certainly lift your spray paint, so in that case it would need to go. I don't know about durepox, but the data sheet I just skimmed suggests the primer is pretty good over other coatings. If it is safe to overcoat then you probably just need to sand back to mainly bare wood.
But I reiterate I don't know for sure. |
|
E.J.
Posting king Joined: 19 Feb 06 Online Status: Offline Posts: 184 |
Post Options Quote Reply Posted: 02 Sep 18 at 4:58pm |
Thanks that’s really useful.
|
|
E.J.
Posting king Joined: 19 Feb 06 Online Status: Offline Posts: 184 |
Post Options Quote Reply Posted: 16 Sep 18 at 10:07am |
Hi, I’m back. As I went to purchase paint based on recommendation here I started to read up on the data sheets of the various 2packs you can get from all of these manufacturers. I can see 3 distinct groups( with a brand that insists it the best option)
high build poly acrilyc (Lechler) 2k Epoxy urethane (durapox) 2k Poly urethane (int perfection) They seem to offer the same thing just at differing cost, with Durapox being the premium, is there an obvious preference for dinghy applications if so what are the differences. I’m willing to pay the cash but want to be sure it’s worth it. Thanks in advance. |
|
Post Reply |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |