Print Page | Close Window

Leak test

Printed From: Yachts and Yachting Online
Category: Dinghy classes
Forum Name: Dinghy development
Forum Discription: The latest moves in the dinghy market
URL: http://www.yachtsandyachting.com/forum/forum_posts.asp?TID=755
Printed Date: 16 Aug 25 at 12:15am
Software Version: Web Wiz Forums 9.665y - http://www.webwizforums.com


Topic: Leak test
Posted By: ssailor
Subject: Leak test
Date Posted: 07 Jun 05 at 8:47pm
Does anyone have any idea what it means if a boat takes on water but when it come to unscrewing the bungs after sailing you can hear the air escape? to me it suggests its air tight!

-------------
Any one in need of quality carbon fibre work (tillers etc) at decent prices!

Int 14 Gbr 1244 'Nucking Futs'

The New Port rule!!.



Replies:
Posted By: Peter Rhodes
Date Posted: 07 Jun 05 at 8:56pm
could be the matterial soaking up water (nothing is totally inpermeable) or even the water in the cockpit!!!

-------------


Posted By: Granite
Date Posted: 07 Jun 05 at 9:24pm
Look for a pin hole below the waterline especialy if your boat has no breather hole, the air in the hull contracts on the cold water and you can get quite a negatave pressure to suck water in

-------------
If it doesn't break it's too heavy; if it does it wasn't built right


Posted By: sailor.jon
Date Posted: 07 Jun 05 at 10:02pm
hen it come to unscrewing the bungs after sailing you can hear the air escaping

this shud mean the hull is water tight or as near as dam it

-------------
Jon
Vortex 1169
http://www.yorkshiredales.sc/ - Yorkshire Dales Sailing Club


Posted By: Scooby_simon
Date Posted: 07 Jun 05 at 10:51pm

the air in the hull contracts on the cold water and you can get quite a negatave pressure to suck water in

Most prolly the cause, when you then get on to the land, the boat heats up and QED + pressure



-------------
Wanna learn to Ski - PM me..


Posted By: redback
Date Posted: 07 Jun 05 at 11:18pm
You've got to remember the hull panels flex in and out as you hit the waves and so some of the time the pressure is less inside than out.  A tiny leak will be alternatively sucking and blowing.  If there is water around the leak then water will get sucked in but run to the lowest point inside so that air get expelled on the next blow.  You then lift the boat out of the water and the air inside warms and expands.  If you then open the bung you release that pressure but find a small amount of water in the hull.  Its common and not to be worried about - just make sure you sponge it out, especially if its a wooden hull and especially if its likely to freeze overnight.


Posted By: MikeBz
Date Posted: 08 Jun 05 at 9:00am
I've had several boats which "whoosh" when you remove bungs or hatches but still take on water.  Never got to the bottom of it though.


Posted By: ssailor
Date Posted: 08 Jun 05 at 3:03pm
Cheers everyone whos put their point in , weve got a feelin its where the spaceframe goes through the hull at one point, once sealed hopefully itll wont leak!! we had noticed that the boat only take the water in when its on its side , if we race and dont capsize it doesnt leak!

-------------
Any one in need of quality carbon fibre work (tillers etc) at decent prices!

Int 14 Gbr 1244 'Nucking Futs'

The New Port rule!!.



Print Page | Close Window

Bulletin Board Software by Web Wiz Forums® version 9.665y - http://www.webwizforums.com
Copyright ©2001-2010 Web Wiz - http://www.webwizguide.com